- Pneumatic Angle Grinder
- Pneumatic Cleaning Gun
- Pneumatic Drill
- Pneumatic Driven Winch
- Pneumatic Grease Gun
- Pneumatic Heavy Duty Rotary Drill
- Pneumatic Hacksaw
- Pneumatic Hand Scaler KC-20
- Pneumatic Impact Wrench 1/2'', 3/4''
- Pneumatic Impact Wrench 1''
- Pneumatic Needle Scaler AMJ-16
- Pneumatic Needle Scaler AMJ-20
- Pneumatic Needle Scaler AMJ-24
- Pneumatic Needle Scaler AMJ-28
- Pneumatic Piston Pump
- Pneumatic Scaling Hammer
- Pneumatic Vacuum Cleaner
Contact Us
Shanghai Allmarine Industry Co.,Ltd.
16-58 Chenbao Road, Malu Industry Park, Jiading Dist., Shanghai City,China.
Tel +86 21-59152099
Fax +86 21-59152055
Fax +86 21-59152055
Email: sales@allmarine.com.cn
Electric high-pressure airless paint sprayer cleaning program
10/17/2012 7:31:21 PM1, the suction tube into a metal container, water or solvent
circulation within the device for 2-3 minutes, turn off the power
switch.
2, in order to save the remaining paint in the paint tube, airless paint sprayer nozzle to paint Tongbi pull the trigger return valve clockwise to tighten, should pay attention to the paint splash, when the paint solvent or water shut nozzle and nozzle placed in metal drums.
3, pull the trigger to make a clean solvent or water circulation in the device for 2-3 minutes, turn off the power switch.
4, the suction tube to bring the suction tube to leave the air-water or solvent metal drums set the return valve reflux position, turn on the power switch, so the equipment within the solvent from the return pipe discharge.
5, Ready to clean solvent or water, and use of low pressure to cycle within the device, such as the use of water to wash until clean, in clean water add a little device protection solution, this way can reduce the high-pressure airless paint sprayer possible within rust.
6, the suction tube is removed from the metal drums containing solvents or water and suction tube filter is clean.
7, checking equipment and nozzle filter is blocked will damage, if necessary, clean or replace.
8, the nozzle is removed from the kegs containing solvents or water, use a soft brush to the nozzle gently brush clean and blown clean with compressed air stored in a dry place.
2, in order to save the remaining paint in the paint tube, airless paint sprayer nozzle to paint Tongbi pull the trigger return valve clockwise to tighten, should pay attention to the paint splash, when the paint solvent or water shut nozzle and nozzle placed in metal drums.
3, pull the trigger to make a clean solvent or water circulation in the device for 2-3 minutes, turn off the power switch.
4, the suction tube to bring the suction tube to leave the air-water or solvent metal drums set the return valve reflux position, turn on the power switch, so the equipment within the solvent from the return pipe discharge.
5, Ready to clean solvent or water, and use of low pressure to cycle within the device, such as the use of water to wash until clean, in clean water add a little device protection solution, this way can reduce the high-pressure airless paint sprayer possible within rust.
6, the suction tube is removed from the metal drums containing solvents or water and suction tube filter is clean.
7, checking equipment and nozzle filter is blocked will damage, if necessary, clean or replace.
8, the nozzle is removed from the kegs containing solvents or water, use a soft brush to the nozzle gently brush clean and blown clean with compressed air stored in a dry place.
